Digital Input/Output and LED descriptions not updating in AQtivate when Live Edit is in use

Digital Input/Output and LED descriptions not updating in AQtivate when Live Edit is in use

Some users might occasionally experience a small problem with digital input/output and LED descriptions. When user changes the descriptions they are updated properly in the relay but it cant be seen in AQtivate setting tool menus. If this happens the values can be updated with the following steps:
1. Disable Live Edit.
2. Click on any of the digital input/output or LED descriptions.
3. Press Enter.
4. Enable Live Edit again.

    • Related Articles

    • Digital input activation troubleshooting

      In case you are having issues with digital inputs not activating when they clearly should be, having a quick look into the Binary Inputs-menu either with AQtivate (shown below) or the relays HMI display. If none of the digital inputs activate the ...

    • Set all digital input thresholds with just a few clicks

      In case you have a lot of digital inputs to configure and all of them have the same voltage connected there is a tool in AQtivate setting tool which will help you set up the voltage threshold of all digital inputs at once. Simply navigate to Tools > ...

    • Tap changer position indication with digital inputs in "binary coded inputs" and "BCD-inputs" mode

      Sometimes tap position is done by using multiple digital inputs. There are two methods for doing this: binary coded decimal (BCD) inputs and binary coded inputs. Both support up to five digital inputs but they use a different number format. Whereas ...

    • Rated voltage and nominal voltages of digital inputs in CPU card and option cards

      Nominal and rated voltages of digital inputs on main CPU board All AQ-200 series units always come with two or three digital inputs in the main CPU board. The rated voltage (maximum operation voltage) of these inputs are always 265 V (AC/DC). The ...

    • Adding or replacing an option card

      If a new option card has been added a script must be run to the relay which updates the hardware configuration of the relay and updates the menu structure. To start the process contact Arcteq Support and list the following details: - Relays serial ...