Using Windows PC to synchronize AQ-200 device time with NTP

Using Windows PC to synchronize AQ-200 device time with NTP

AQ-200 devices support NTP time synchronization. Windows PC can be one option to use as an NTP time synchronization source. Windows also comes with NTP server version 3.0. While this can be used for synchronizing time for AQ-210 framedevices, AQ-250 series devices don't support this. AQ-250 frame devices require NTP protocol version 4.0.

To synchronize time of AQ-250 frame device you will need to use a software that uses NTP server version 4.0.

Meinberg NTP software is one of many programs that support NTP protocol version 4.0.

    • Related Articles

    • Timesynchronization with DNP3 communication protocol

      Enabling serial based DNP3 Serial DNP3 can be enabled with Protocol parameter at Communication > Connections menu at Serial section. Set the Slave address and other settings at Communication > Protocols > DNP3. Serial based time synchronization In ...

    • Timesynchronization with IEC61850 communication protocol

      Enabling IEC61850 IEC61850 can be enabled at Communication > Protocols > IEC61850. Set the IP address used by IEC61850 at Communication > Connections. Time synchronization Set Time sync. source parameter to NTP at General menu. Set the NTP server IP ...

    • Timesynchronization with IEC101 communication protocol

      Enabling IEC101 IEC101 can be enabled with Protocol parameter at Communication > Connections menu at Serial section. Set the IEC101 addresses at Communication > Protocols > IEC101/104. Time synchronization Set Time sync. ...

    • Timesynchronization with ModbusRTU and Modbus TCP communication protocols

      When Modbus communication protocol is used, time synchronization setup depends on which type of Modbus is used: ModbutRTU (serial) or ModbusTCP(NTP). ModbusRTU (serial) Enabling ModbusRTU Modbus RTU can be enabled with Protocol parameter ...

    • Modbus communication in AQ-200 series IEDs

      AQ-200 series devices can communicate using both Modbus RTU serial protocol and Modbus TCP protocol. Same data can be accessed using both these protocols. To use Modbus TCP it can be activated with parameter Modbus TCP enable in menu Communication à ...